1/5/2024 0 Comments Saffire mixcontrol metersThat's it, the KEMPER SPDIF in shoudn't connect to anything in the scenario you're looking for.Ģ-Make sure computer is on and SPDIF is connected using USB (you will not hear a sound if computer is off), then go into Focusrite options and make sure that SPDIF is set to 44.1KHZ sampling rate since the Kemper doesn't support higher rates.ģ-Using the computer If you can get to the Focusrite Mixer, open it and play anything on the Kemper, watch if the meters in Focusrite mixer move. I'm not sure what you mean here, please don't mind me if I misunderstood but the simple connection should be,ġ- Kemper SPDDIF out connects to Focusrite SPDIF IN. This video shows how to set up the Saffire Mix Control so that the Headphone Volume is NOT controlled by the main volume knob on the front of the unit. Your setup and settings in the Saffire MixControl software. ![]() Ensure that the mixer output is stereo by clicking on the stereo button (below the meters of the output channel). This is easily setup using its included 18 X 16 DSP mixer/routing software called Saffire MixControl. for routing audio between software applications via Saffire MixControl. 5 Unit 1 Setup Cue Mix (unit 1) Open Saffire MixControl. "kemper hooked up via SPDIF cables to focusrite (in to out, out to in) 18-Input/8-Output Interface 4 Focusrite Preamps 24-Bit/96 kHz Audio Resolution. It features flexible output routing and monitoring, as well as intuitive one-click set-up. Saffire MixControl, the ultra-low-latency 18 x 8 DSP mixer/router software provided with Saffire PRO 24, sets a new standard at this price point for audio interface control. Thanks in advance for any and all help as well your patience for my questions. The Saffire PRO 24 offers the best sounding interface in its class. This stuff is way more difficult than I had expected especially for someone with little to no background with any of it. ![]() Ha! Could someone help me with the very very basics here.? or possibly refer me to the page in the reference manual that might help? I have guitar plugged into kemper, kemper hooked up via SPDIF cables to focusrite (in to out, out to in) and monitors hooked up to audio interface (outputs 1 and 2 on the Focusrite) I currently have no sound and I'm assuming that it has something to do with the inputs or outputs I have selected in the Kemper, there quite a few different options and ouputs (Main, Monitor, Direct and SPDIF) I'm so confused? I am just attempting to get sound out of the kemper through the monitors at this point. Decided to play around and add in audio interface and now I'm lost with no sound. I was using a simple setup of studio monitors hooked up directly to kemper and playing fine. Included with the PRO 14 is Saffire MixControl, an 18 x 6 DSP mixer. ![]() I have never used an audio interface before until today. With eight inputs, two award-winning Focusrite microphone preamps and six outputs. Ok.I'm totally lost but have to start somewhere I suppose.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |